Need advice, can't get into gear when car is started...
#22
On The Tree
Thread Starter
iTrader: (5)
Join Date: Nov 2010
Location: Tahlequah, OK
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Looks as though i may have to as i'm running out of options lol. I'll try adjusting the master more. It did seem to make a very minor difference but not good enough. The only other thing i can think of besides the slave would be the clutch itself.
EDIT: The slave cyl is leaking slightly, hard to catch but now i am sure it is the culprit in all of this.
EDIT: The slave cyl is leaking slightly, hard to catch but now i am sure it is the culprit in all of this.
Last edited by MR_M; 08-11-2011 at 06:07 PM.
#23
Launching!
iTrader: (5)
Join Date: Oct 2009
Location: North Carolina
Posts: 218
Likes: 0
Received 0 Likes
on
0 Posts
I had a similar problem after my swap, long story short is the tranny is now rebuilt to Viper Spec. Some douche sold me a "in good working condition" T56 and it was trashed. I hope that ends up not being your problem