transmission mount (m6) help!
#1
On The Tree
Thread Starter
Join Date: Apr 2011
Location: Houston/ Kingsville,Tx
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
transmission mount (m6) help!
ok so yesterday i replace my heavly cracked energy suspension transmission mount with an anchor transmission mount . when i removed the jack i noticed the stick was sitting lower than normal... was i supposed to buy a spacer? but i continued to get a hit from the transmission when i hit a bump or vibration when i hit 70 , what is the problem
#2
Check with your Jack to see if there is play in the tranny mount if it moves up or down at all if so get some washers or make some spacers for the bolt that goes through k member.....lmk how it goes my foxy lady still calling ur name whenever ur ready Bro
#3
On The Tree
Thread Starter
Join Date: Apr 2011
Location: Houston/ Kingsville,Tx
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
ur gonna need more boost for me bro lol jk
#5
Internet Mechanic
iTrader: (17)
Ever since going to a ES bushing and a TQ arm relocation kit, I have had a vibration. People mentioned it with the PRE load plate, or the bumps, at this point I am putting the rubber back in since the stress is off the tail shaft anyways and the front is Rubber.
I personally never noticed a height difference but then again I was not looking that hard.
I personally never noticed a height difference but then again I was not looking that hard.
#6
Launching!
iTrader: (8)
Join Date: Aug 2010
Location: Memphis
Posts: 291
Likes: 0
Received 0 Likes
on
0 Posts
If the shifters sittin lower that would mean that the bushing you replaced it with is taller than the energy suspension one.... So u dont need a spacer, maybe u need to take out a spacer...