blown1967camaro

Is it possible to machine the stock lt1 flywheel by re-drilling the mounting holes to fit onto a early sbc? Thus can keep everything made for the lt1 trans? Or what other flywheels will work, only found $400 dollar ones that accept the pull style?

Thanks

Leftoverchinese

I think they are balanced differently and so the flywheel wont work.

americanmuscle13

Ive got the center force on mine, it works fine wasn't cheep though. My issue is trying finding a twin disc for this setup

blown1967camaro

Americanmuscle do you know the parts number for the flywheel/clutch you have?

americanmuscle13

i gotta look for the receipt ill get it though