Need help with T56 Hydraulic system
#1
12 Second Club
Thread Starter
iTrader: (6)
Join Date: Mar 2012
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
Need help with T56 Hydraulic system
So had my trans rebuilt, put in new clutch, flywheel, pressure plate, pilot bearing, slave cylinder, tick master cylinder, and a remote bleeder (Not the tick). I had everything back together Monday night, filled up the clutch reservoir and decided I would bleed it Tuesday. Walk outside Tuesday and clutch fluid is on the ground and reservoir was empty. Leaking between the block and the bellhousing. Pulled the trans back, got another slave just to see, filled it up last night and this morning same thing Now i'm wondering if I pull the trans back enough to see the slave and everything, can I press the clutch pedal and try to see where it's leaking from???? I'm just not sure if I will damage the slave or what. Only thing I can think of is maybe the remote bleeder.
Last edited by White6SpdZ28; 04-11-2012 at 11:48 AM.
#3
12 Second Club
Thread Starter
iTrader: (6)
Join Date: Mar 2012
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
I tried to see but honestly couldn't tell. That's why I am also curious to know if I will mess anything up if I slide the trans back about 6 inches and have someone press the clutch to see if I can see where its leaking from or do I risk blowing out the slave cylinder?
#4
I tried to see but honestly couldn't tell. That's why I am also curious to know if I will mess anything up if I slide the trans back about 6 inches and have someone press the clutch to see if I can see where its leaking from or do I risk blowing out the slave cylinder?