How to remove PITA reverse thrust washer?
#1
TECH Enthusiast
Thread Starter
Join Date: Jan 2003
Location: Birmingham, AL
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
How to remove PITA reverse thrust washer?
Disassembling a T56 and the thrust washer above reverse will not come off. It stops above the snap ring groove. Any ideas? Thanks!
#2
TECH Enthusiast
Thread Starter
Join Date: Jan 2003
Location: Birmingham, AL
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
OK, it seems there is a tiny ridge where I guess the snap ring was turning or there was pressure on it. What should I do to take down this ridge and not damage the surface of the shaft?