Ok, so I'm about to install a Viper remote start and keyless entry system into my 01 M6 Trans Am. I am a seasoned car electronics installer, so info on how to get the remote start to work with a manual isn't what I'm after here, I've got that covered. I was wondering if anyone knew if there was a wire on the T56 that gave a +12v or (-) signal depending on if the transmission was in gear or not. I would like to use a wire like this if it exists in order to ensure the car doesn't remote start in gear.

 

as far as i know, no theres no wire thats hot at all times. the pcm gives power the the reverse lockout when the key is turned but idk if that helps you at all?