t56 bushing help!!!
#1
Launching!
Thread Starter
iTrader: (3)
Join Date: Jun 2011
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
can anyone help me out as in the middle of putting a new tailshaft bushing in my trans.i have the old out and tailshaft off the trans and ready to install new one.my questions is i have loctite green(believe this is what i want to use) but ive been trying to search about what exactly to "stake" the bushing means? can anyone help me please trying to get it done asap! thanks
#3
TECH Addict
iTrader: (4)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Use a good driver. Look how pretty it is as it squishes into the oil grooves.
Shove a known good slip-yoke into it and rotate that slip-yoke around to smooth things out a bit.
Prepare to do that again when it's installed. The green and staking is pointless (even if RSG says so and prepare to have problems with their bushing too)
I've had the remover / installer tool.
I've had a tool made to install the bushing.
It will still swell into the grooves.
You're welcome.
Shove a known good slip-yoke into it and rotate that slip-yoke around to smooth things out a bit.
Prepare to do that again when it's installed. The green and staking is pointless (even if RSG says so and prepare to have problems with their bushing too)
I've had the remover / installer tool.
I've had a tool made to install the bushing.
It will still swell into the grooves.
You're welcome.