Transmission repair advice: Rattling noise inside of transmission
#1
TECH Enthusiast
Thread Starter
iTrader: (17)
Join Date: May 2004
Location: GA
Posts: 667
Likes: 0
Received 0 Likes
on
0 Posts
Hey guys, I have a tick performance super magnum tr6060 that was brand new for a build of mine. I used it on jack stands to break in a new rear and that's it. It managed to scrape up the input shaft behind the slave cylinder from a slave shim, but it isn't a structural issue as the spline end is fine. My issue is, after I shipped the tranny to a buyer, the buyer send a video of him rotating the transmission and you can hear a rattling noise like a "ball bearing" as he described it, is rolling around loose in there. I am not a tranny guy (poor choice of words) so I am not going to tear into this thing. Anybody who has experience on working on these things will likely be getting a steal with this. I will sell it as is for $3000 plus shipping and I am sure my listing price is more than fair since you can get just about any part needed plus repairs for far less.
Last edited by LT1TA; 02-15-2015 at 12:30 PM.