clutch air gap..
09-20-2015, 08:53 PM
#1
TECH Fanatic
Thread Starter
iTrader: (12)
Join Date: Jun 2007
Location: earth
Posts: 1,438
Likes: 0
Received 0 Likes
on
0 Posts
clutch air gap.. Installing my spec twin disk bell housing to pressure plate is 2.460. Throw out to bell housing surface is 2.110 with the .120 shim behind the slave. That leaves .350 I've read up to .250 is ok. I know as the clutch breaks in this gap will shrink so I'm just curious how much room people normally get away with
10-16-2015, 07:58 PM
#2
Teching In
Join Date: Aug 2015
Location: Milwaukee
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts