rcarson

iTrader: (12)

So, have the stock 4th gen master installed and looks good, but the little pin that holds the clutch line into master is missing. Any clue what size screw can go in to replace it or where I can get another pin to hold the line in place? Stupid question I know but would be helpful to not have to trial and error it especially with everything in the way.

BALLSS

cut a piece of nail the size of the hole.

or a good hardware store may have a selection of roll pins which is what you have missing

rcarson

iTrader: (12)

Thank you on the roll pin reference. I was totally blanking on what that pin was called. Does anyone know the size of that hole or the roll pin that goes in it?

s30.hybrid

iTrader: (3)

Do you have a set of drill bits? You may be able to find the pin size by matching it to a drill bit. Use the non fluted end to test fit it into the hole.

CattleAc

iTrader: (7)

.131 roughly...

rcarson

iTrader: (12)

Thanks, exactly what I was looking for