Help Is Clutch Disc Good?
You need to get a micrometer and measure the thickness of the pads. Saying "about 1/8th inch" is not going to cut it. Is the Spec specification a minimum thickness, or is it the thickness of the pad when its new? .310 inch = 310 thousands
Andrew
Andrew
see i bought it used and they said it was broken in properly and only had 1000 miles on it now this is costing me down time with my car i just asked him to refund half of what a new disc would cost which is 160 so id want 80 back and then he just told me they can repuck oen for 50 so i asked him to send 50 back i think thats fair enough
Trending Topics
LS1TECH Sponsor
iTrader: (33)
Joined: Jul 2002
Posts: 4,399
Likes: 0
From: Out on the farm in Central IL
It's not just the disk. Check the PP and FW as well. If you install a new disk on a grooved PP and FW you will be in the same place in a month or 2.
I would als change the slave. It's a lot easier to do with the trans out already.
I would als change the slave. It's a lot easier to do with the trans out already.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo