spec III clutch question
#1
Staging Lane
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: maryland
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
spec III clutch question
I just got my car and it has a spec III init.I was told buy the seller that it needs a clutch master cylinder for a 01 or 02 camaro because it will run out of fluid under hard driving and stick in gear
Is this true,the car shifts fine but i have not run it hard yet.Has anyone run into this and is there a special afetmarket part or just call GM and say i nedd it for an 01 or 02.
Is this true,the car shifts fine but i have not run it hard yet.Has anyone run into this and is there a special afetmarket part or just call GM and say i nedd it for an 01 or 02.
#2
SSU'S Vice Mod
Join Date: Jul 2004
Location: Hazard Co. Maryland
Posts: 2,391
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by kilr12
I just got my car and it has a spec III init.I was told buy the seller that it needs a clutch master cylinder for a 01 or 02 camaro because it will run out of fluid under hard driving and stick in gear
Is this true,the car shifts fine but i have not run it hard yet.Has anyone run into this and is there a special afetmarket part or just call GM and say i nedd it for an 01 or 02.
Is this true,the car shifts fine but i have not run it hard yet.Has anyone run into this and is there a special afetmarket part or just call GM and say i nedd it for an 01 or 02.
check your PM here in about 30 seconds.