Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Quick question

Thread Tools
 
Search this Thread
 
Old 07-10-2005, 07:00 PM
  #1  
Staging Lane
Thread Starter
 
Canuck's Avatar
 
Join Date: May 2005
Location: windsor, ontario
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts

Default Quick question

What is a 1/4" breaker bar needed to bleed my hydraulics? Thanks
Old 07-10-2005, 07:30 PM
  #2  
TECH Apprentice
iTrader: (1)
 
GETSOMZ28's Avatar
 
Join Date: Nov 2001
Location: Albuquerque, NM
Posts: 316
Likes: 0
Received 0 Likes on 0 Posts
Default

???? I just used a 13mm socket and 3/8" wrench with no problems.
Old 07-10-2005, 09:15 PM
  #3  
Staging Lane
Thread Starter
 
Canuck's Avatar
 
Join Date: May 2005
Location: windsor, ontario
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts

Default

Thank you. Did you put the cap on the reservoir when the clutch pedal was depressed during the bleeding? I was wondering if the fluid would spill back out. BTW your 02 Z must handle like a MF with all those susp. mods.
Old 07-10-2005, 09:25 PM
  #4  
TECH Apprentice
iTrader: (1)
 
GETSOMZ28's Avatar
 
Join Date: Nov 2001
Location: Albuquerque, NM
Posts: 316
Likes: 0
Received 0 Likes on 0 Posts
Default

Heres, what I do:

push clutch in (hold it)

open bleeder (fluid or air will come out)

close bleeder

release clutch

pump it a couple times then do it again (4-5 times should do it)

Thanks...the cars handles great!




All times are GMT -5. The time now is 10:22 PM.