Refacing flywheel
02-14-2006, 05:01 PM
#1
Staging Lane
Thread Starter
iTrader: (4)
Join Date: Jan 2005
Location: Colorado
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Refacing flywheel I pulled the old clutch out and am replacing it with a slightly used Z06 clutch. The new clutch didnt come with a flywheel, and after it was refaced it had .050 taken off it. Am I going to have a any clamping problems with this as there are no shims available?
Thanks, Matt
Thanks, Matt
02-14-2006, 06:28 PM
#2
Why are there no shims avalible? It would seem to me that if you shim your slave the same amount the flywheel has been turned you would be fine.
As a side note however, I would not reuse a stock flywheel after it has been turned more than .030" FWIW
As a side note however, I would not reuse a stock flywheel after it has been turned more than .030" FWIW