I was at funday today and my first pass was ok...then on the second pass, i droped it at 2500 and the clutch pedal only came up an inch...the RPM's rose quicker than normal with no wheel spin...the damn clutch wouldn't come off the floor...i had to let off of it, pedal it a few times so it would come up, then limp down the track...it only stuck in first...the third pass it stuck in first and second...this pissed me off, and the clutch definately got glazed...this isn't the first time i had this problem...this is the 3rd incident in the past year...is this prob the slave cylinder? It has been to the dealer once with this above prob...what can i do???? any suggestions on the prob? what clutch/flywheel setup are u running cause it seems like it needs to be changed...thanx
thanx

 

Your clutch is definitely done. Im about to try out a RAM 6130 disk + 402 pressure plate because Ive heard alot of good things about it. If you have $900 to spend Id get a McLeod.

Id go ahead and replace the slave cylinder and the master clyinder to '01 or newer.

Hope this helps.

<img border="0" alt="[Burnout]" title="" src="graemlins/burnout.gif" />