drill nod questions
Thread Starter
TECH Apprentice
Joined: May 2005
Posts: 314
Likes: 0
From: Huntsville, AL
drill mod questions while doing the mod, it seems as though the restriction is actually moving down the line. is this possible? I have drilled over 1 inch and still is hitting something in the line. I NEED HELP!!!
Last edited by Prin; Jan 27, 2007 at 05:13 PM.
If you have the right diameter drill you'll be good. The restriction is about an inch or so down the line. Drill right through and make sure you're drilling exactly straight (and the line is straight) or you're gonna mess up the line.
I used a 1/8 inch bit and I see what you are saying about the restriction moving down. I thought the same thing as I was doing mine. Just keep the line straight and make sure you have a good bit and go until it moves through easily.
