Getting my Clutch and Hydraulics done, Check it out
#1
Scammer Alert!
Thread Starter
iTrader: (9)
Join Date: Apr 2007
Location: Richmond, Illinois
Posts: 461
Likes: 0
Received 0 Likes
on
0 Posts
Getting my Clutch and Hydraulics done, Check it out
ok, i am going to be getting the ls7 clutch, pressure plate and flywheel, roller throwout bearing, new slave cylinder, and the drill mod, done, The problem i was having was spongy clutch, sticking at high rpm shifts and not engaging on high rpm 2-3 shift, my car also has 65,000 miles so i think the clutch needs to be replaced and since i am doing a cam in the next month this was a must, do you guys think this will solve the problems i was having?
#2
On The Tree
iTrader: (8)
Join Date: Dec 2004
Location: Huntsville, AL
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
I just ordered my LS7 clutch kit, slave, & pilot bearing today and I'm doing the install this weekend. I've been having the same problems you're having and I've already done the drill mod and a new master cyl. I think the issues are caused by the old slave cyl. Good luck with it.