BIG problem

Reply Subscribe

Thread Tools

Search this Thread

Nov 15, 2007 | 09:21 PM

00'T/A

Thread Starter

Registered User

Joined: Jul 2007

Posts: 2

Likes: 0

BIG problem

Alright so my dad and i just got done putting everything back together after having pulled the transmission to replace the rear main seal. we decided it would be a good idea to bleed the clutch as well since mine was sticking. While we were doing so my dad dropped the bleeder screw into the bellhousing!!!!! please tell me we dont have to completely undo everything we just did in order to get that bleeder bolt back out. is there another way? we tryed sticking a magnet through the hole were the starter is but we just couldnt drag it back up. does anybody have any ideas other than pulling the tranny back out? PLEASE HELP!!!

Nov 15, 2007 | 10:34 PM

TheLS1Kid

TECH Fanatic

iTrader: (12)

Joined: Oct 2006

Posts: 1,724

Likes: 0

From: Orlando, FL

Just unbolt the tranny and slide it back an inch or two so you can slide your hand in there and get the screw. You don't have to take the whole tranny out.

Nov 16, 2007 | 07:07 AM

00'T/A

Thread Starter

Registered User

Joined: Jul 2007

Posts: 2

Likes: 0

yea but with being able to slide the tranny back comes the PITA of taking a whole bunch of **** out, driveshaft torque arm etc, thats what i was trying to avoid

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last