oops!!!!
oops!!!! well i was bleeding the clutch on my car bymyself using the hole i cut in my floor everything was going good until i tightened it one last time 
then i think it broke. i was wondering if this has happened to any of you and also if you could tell me what could have broke because i think everything that did fell in the trans except the socket
but if you guys could just tell me what the screw could have taken with it to the depths of my bell housing.
thanks
then i think it broke. i was wondering if this has happened to any of you and also if you could tell me what could have broke because i think everything that did fell in the trans except the socket but if you guys could just tell me what the screw could have taken with it to the depths of my bell housing.thanks
so the bleeder valve broke?? wow...talk about too much tightening!!
unless the slave broke apart...there isn't much to break off. but you'll need to pull the trans to get the old bleeder out and put a new one in.
unless the slave broke apart...there isn't much to break off. but you'll need to pull the trans to get the old bleeder out and put a new one in.
