OK heres the deal we are workin on a 37 sedan fiberglass kit car, with a crate motor ls1 t56 setup. ALL NEW PARTS!!!

now the problem we are having is the clutch will not engage. You can push the clutch in and it goes in gear perfect, but when released the car will hardly move. Its weak enough you can start the car with it in gear, without even pushing the clutch pedal in. We have blead it, pulled the trans and inspected everything, and even adjusted the willwood master.

Im outta ideas!!!

You guys have any?

 

Clutch disk hanging up on input shaft?

 

what clutch you may need a shim

 

Is that willwood master adjustable?
Is it adjusted properly?
Something has to be keeping the pressure plate from fully clamping the disc if it slips that bad.