Clutch?
Thread Starter
On The Tree
Joined: Jun 2008
Posts: 166
Likes: 0
From: Wake Forest,NC
Clutch? I have a 02 Camaro SS SLP #5878 and it recently got a new Centerforce Dual Clutch and a new Rams Billet Steel flywheel, and new throw out bearing.I have started to feel a lot of vibration on my stick shift and my pedal especially at higher rpm. Once when I was racing in fourth gear I was going to shift into fifth and it did not let go of the fourth gear until the rpm got lower?What could it be?Thanks
could be as simple as a bad trans mount.
more than likely its a slight mis-balance in the clutch/flywheel setup.
as for not coming out of gear...my guess is somethign with the master, possibly due to the "drill mod" restriction...or possibly air in the system.
more than likely its a slight mis-balance in the clutch/flywheel setup.
as for not coming out of gear...my guess is somethign with the master, possibly due to the "drill mod" restriction...or possibly air in the system.
Thread Starter
On The Tree
Joined: Jun 2008
Posts: 166
Likes: 0
From: Wake Forest,NC
It got a new master too and I already did the drill mod.I sound kind of dumb but I never done it before or seen anyone do it, but how do you take the air in the system if it has?
