When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey everyone, have a few "misprints" I've accumulated from trying different settings that I'll sell for $15 shipped each.
All of these will still clip into the cubby hole the same. The main issue with most of them is that the gauge pod hole is maybe 1mm-2mm too big so the gauge will slide out. As a test I put a few pieces of masking tape around my gauge and it fit snug and was not going anywhere.
There is also a couple of them could probably use some sanding. There is a bit of warping on one side of the extension for the pod. I can send more pics for anyone that's interested
I wish you were close to me. I have a lot of simple ideas that would do great. I am no 3D printer guy and definitely not a computer guy. But I have some killer ideas. A few of mine have already been "stolen", per say. I just don't really know anyone with a 3D printer. I just work on cars at work then come home and work on cars.
I wish you were close to me. I have a lot of simple ideas that would do great. I am no 3D printer guy and definitely not a computer guy. But I have some killer ideas. A few of mine have already been "stolen", per say. I just don't really know anyone with a 3D printer. I just work on cars at work then come home and work on cars.
I take requests if you have something you'd like to see!
11-12-2021, 02:17 PM
