Description:

This is a PWM fan controller from a 2006 Ford Focus. I cleaned this one up and don't need it anymore. This is the only one I found that had all the connectors with it.  I am running the same setup on my 65 nova 5.3 swap controlled by Holley Terminator. This is a great and easy way to control your fans with PWM. I am using it with some 2000 F-body fans and it keeps my temps within 2 degrees even when it is 110 out in AZ. I have also tested this unit on my car to make sure it functions correctly.

You just need to run +12v, Ground, and a output wire from the Holley harness configured to PWM. The other two wires are the output to the fans you are using. If you need help setting it up or tuning with it, I would talk to Dr. EFI(Project GatTagO). He was super helpful in getting mine all set up!

$100 shipped