Heads Up Racing Next Friday at Eddyville Raceway Park
#143
wow i missed the boat on that one, must not have gotten the memo...might have the car done, might not, thursday i am hanging quarter number 2 then i'm gonna be spending a lot of quality time with the sanding blocks. i'm hopefully gonna have a jegs tq arm in it soonish. gonna give it a try since i left all the holes there LOL
#144
Launching!
Thread Starter
iTrader: (14)
Join Date: Oct 2005
Posts: 275
Likes: 0
Received 0 Likes
on
0 Posts
It's all good.
Look how much pre-fabrication was done, I mean ****, holes already drilled in the tunnel for a torque arm mount... Musta got it from a high end chassis shop!
....or just my garage haha
Look how much pre-fabrication was done, I mean ****, holes already drilled in the tunnel for a torque arm mount... Musta got it from a high end chassis shop!
....or just my garage haha
#145
i might go with a bmr, i think i found one for too cheap to pass up, the 5.3 is going in there now with heavy doses of nitrous till it pops. anyone got experience with 5.3's and about a 200 hit of squeeze?
#147
11 Second Club
iTrader: (5)
Join Date: Sep 2005
Location: Monroe, Iowa
Posts: 1,024
Likes: 0
Received 0 Likes
on
0 Posts
I have a 5.3 in my truck and i'm assuming thats the motor your putting in without the truck intake manifold. Your best bet on research with those motors would be prob. be performancetrucks.net and see what those guys are running for a safe shot on their trucks. Just a guess, but a 200 might be a bit much haha