My newest project - 1990 Ford Bronco
#1
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2007
Location: Rochester, NY
Posts: 1,450
Likes: 0
Received 0 Likes
on
0 Posts
My newest project - 1990 Ford Bronco
I finally picked up my 1990 Ford Bronco from Massachusetts. It needs some work, but overall I think it's going to be a great truck to start out with. It has about 160k miles but its pretty clean.
It will be getting a new engine over the winter. I'm not sure if I want to do a 351 yet, but it has the 5.0 and it will be getting a lift as well.
I'm excited. It's my first ford vehicle and I can't wait to start tearing into it.
It will be getting a new engine over the winter. I'm not sure if I want to do a 351 yet, but it has the 5.0 and it will be getting a lift as well.
I'm excited. It's my first ford vehicle and I can't wait to start tearing into it.
#5
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2007
Location: Rochester, NY
Posts: 1,450
Likes: 0
Received 0 Likes
on
0 Posts
Z06 is getting a 408.
Formula is getting the Z06's old setup
Bronco is getting new suspension/engine swap.
The Z06 and Formula werent going to be used in the winter anyways.
I'm hoping to be able to do the bronco in small stages. It runs/drives. Just leaks oil very bad. I can drive it for now, buy everything, then just go ham over a week with it.
Thats the plan anyways. If not, I can borrow my roommates van for a bit.