What would I need to complete Swap?... PLEASE HELP, GOT STUCK!!!
#22
12 Second Club
Join Date: Aug 2012
Location: central pa
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Im removing my Ls6 intake stock set up and Installing a Fast 92 Intake. Here is the parts list... Fast 92 intake, 92mm Throttle body, 85mm MAF sensor, 92mm Lid.
All i would be needing is a bellow, right? so what can be used for that? Would a Fenco rubber coupling do? Thats what i currently have on right now for a bellow, not sure if 4in diameter would work.
Pieces should bolt right on, please let me know if im missing anything else.
Thx...
All i would be needing is a bellow, right? so what can be used for that? Would a Fenco rubber coupling do? Thats what i currently have on right now for a bellow, not sure if 4in diameter would work.
Pieces should bolt right on, please let me know if im missing anything else.
Thx...
#25
TECH Enthusiast
iTrader: (24)
Join Date: Oct 2010
Location: Plano, TX
Posts: 731
Likes: 0
Received 0 Likes
on
0 Posts
If you already have the 85mm MAF, I would just buy the adapter. I only paid $24 for mine shipped. I seriously doubt that it will be a restriction unless you plan on having alot of Hp. Your car shouldn't be running that bad also and I would not be going WOT until you get a tune. I drove my car 50 miles home after my installation and it only had high idle problems. I did find out I had a vacuum leak behind intake but got it taken care of.
#26
11 Second Club
Thread Starter
iTrader: (15)
Join Date: Nov 2010
Location: Austin, TX
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
If you already have the 85mm MAF, I would just buy the adapter. I only paid $24 for mine shipped. I seriously doubt that it will be a restriction unless you plan on having alot of Hp. Your car shouldn't be running that bad also and I would not be going WOT until you get a tune. I drove my car 50 miles home after my installation and it only had high idle problems. I did find out I had a vacuum leak behind intake but got it taken care of.
I ordered the adaptor, and will go this route, I may sacrifice 5hp, but then again my 224r cam is not a beast by no means.
#31
11 Second Club
Thread Starter
iTrader: (15)
Join Date: Nov 2010
Location: Austin, TX
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
I got my casper 3/5 harness adapter for the 85 MAF. My question now is... What do I do with the stock IAT sensor? Do I hook it up since the 85 MAF already has one built in?