***Rising From the Ashes Pt. 2***
#105
11 Second Club
Thread Starter
iTrader: (15)
Join Date: Nov 2010
Location: Austin, TX
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
Thank you!... and I'm just waiting for Pat G to create a tune and send to a local shop so I can get my break in tune downloaded. 1.5K miles afterwards, and its time to Go see him in Victoria, TX and do the real thing!
I am Excited to announce that my ride is completely assembled, down to drive shaft and kooks exhaust. Only thing lacking is a straight trough bullet and dump pre axle, but need a muffler shop for that.
I am Excited to announce that my ride is completely assembled, down to drive shaft and kooks exhaust. Only thing lacking is a straight trough bullet and dump pre axle, but need a muffler shop for that.
#114
12 Second Club
iTrader: (5)
Here it is as how it fits with the QTP off road Y pipe, it fit right in so I believe it's the 40085.
You can get QTP electric cutouts if you want that extra sound/flow. I believe they are worth about 6rwhp last time I had checked that kind of setup. Here's an article about them: http://www.hotrod.com/techarticles/h...haust_cutouts/
So if you want to squeeze the most that you can, go for it.
You can get QTP electric cutouts if you want that extra sound/flow. I believe they are worth about 6rwhp last time I had checked that kind of setup. Here's an article about them: http://www.hotrod.com/techarticles/h...haust_cutouts/
So if you want to squeeze the most that you can, go for it.
Last edited by Roarin_8; 11-24-2013 at 12:28 PM.
#115
11 Second Club
Thread Starter
iTrader: (15)
Join Date: Nov 2010
Location: Austin, TX
Posts: 881
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info... I will be going with a 40085 borla, sounds good, and revies are good. Cut out is a must as i will be spraying this set up and need to exhaust with no restrictions.