toolguytodd

Putting a 2001 6.0 in a jeep. First harness was from novak. Sent my ppm off to them for reprograming. puy together and don't seem to have any spark. I then bought a painless harness and sent ppm off to them for reprograming. I have replaced my coils and the coil wire harnesses. Replaced both the crank and cam sensor. At the coil input plug I have 12v at one pin with sound at opposite pin. tried a noid tester on signal but It did not light up. Btw this engine came out of a truck that was t boned. Could timing chain have jumped?
Idea's
Todd