New LS1 Owners - Newbie Tech Basic Technical Questions & Advice
Sponsored by:
Sponsored by:

2019 silverado 6.0 no start

Thread Tools
 
Search this Thread
 
Old Dec 26, 2024 | 12:32 AM
  #1  
4x4k30's Avatar
Thread Starter
Teching In
5 Year Member
 
Joined: Aug 2017
Posts: 7
Likes: 1
Default 2019 silverado 6.0 no start

ok i have a 2019 silverado with the 6.0 engine i bought it at a auction with no key had a key made but couldnt get it programmed fooling with it i did the 30 min. relearn the truck started and ran fine but the service theft light was still on so i got in the truck to drive it and check it out and when i drove it around the block the oil pressure dropped i was not but 4 mins . from my house so i kept driving it and when i got home the engine died and would not start back it will turn over i looked under the hood oil was everywhere the oil cooler line had came off the little clip that holds it in was gone i filled it backup with oil and it would not start so i had the key man come out and program the key so the theft light is off so i thought it was because of the theft light it had some reason why it would not start but its off and still the truck just wont start i cant figure out what happen i thought i had done ruined the engine running it with out oil pressure but it did not lock up or make any knocking noise when i drove it back home it just cut off and wont start any ideals what is causeing the truck not to start it has no codes?

Last edited by 4x4k30; Dec 26, 2024 at 12:38 AM.
Reply
Old Dec 26, 2024 | 06:12 AM
  #2  
Ls7colorado's Avatar
TECH Addict
20 Year Member
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Jul 2005
Posts: 2,116
Likes: 609
From: Henderson, TN
Default

aint got no gas in it
Reply
Old Dec 26, 2024 | 07:39 AM
  #3  
4x4k30's Avatar
Thread Starter
Teching In
5 Year Member
 
Joined: Aug 2017
Posts: 7
Likes: 1
Default

Originally Posted by Ls7colorado
aint got no gas in it
yea i put some gas in it tryed to check fuel pressure but no where on fuel rail is there a fitting hooked up my scanner and it does not read fuel pressure either fuel pump is running
Reply
Old Dec 26, 2024 | 09:05 AM
  #4  
Ls7colorado's Avatar
TECH Addict
20 Year Member
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: Jul 2005
Posts: 2,116
Likes: 609
From: Henderson, TN
Default

If you have compression and spark which I'm sure you checked before posting this, then spray a little bit of starting fluid in the air intake and see if it tries to fire.
Reply




All times are GMT -5. The time now is 02:18 AM.