Ported MAF
Thread Starter
TECH Regular
iTrader: (202)
Joined: Nov 2004
Posts: 490
Likes: 0
From: Memphis, Tennessee
Ported MAF Well I was doing the FRA mod and some other things today and got my stock maf all dirty with plastic bits. My friend had a stock tb off his 99 that he ported and said that we could just use that. I would probably have to post pics of it to show you how it is ported. Is it worth it to run those ends or clean up my stock ones?
PS: Do I need to reset my computer to learn the new mods or does it take a while on its own?
PS: Do I need to reset my computer to learn the new mods or does it take a while on its own?
If you aren't prepared to tune it (adjust the MAF table)
then don't go there.
Take your screened end off, and blow the plastic out
of it with shop air or use a garden hose, and then put
it back on.
then don't go there.
Take your screened end off, and blow the plastic out
of it with shop air or use a garden hose, and then put
it back on.
Thread Starter
TECH Regular
iTrader: (202)
Joined: Nov 2004
Posts: 490
Likes: 0
From: Memphis, Tennessee
Originally Posted by jimmyblue
If you aren't prepared to tune it (adjust the MAF table)
then don't go there.
Take your screened end off, and blow the plastic out
of it with shop air or use a garden hose, and then put
it back on.
then don't go there.
Take your screened end off, and blow the plastic out
of it with shop air or use a garden hose, and then put
it back on.
Thread Starter
TECH Regular
iTrader: (202)
Joined: Nov 2004
Posts: 490
Likes: 0
From: Memphis, Tennessee
Originally Posted by Kurt D
Descreen but don't port, as in cut the fin out of, the MAF. It can throw you off that much.
