ORY probs...
ORY probs... i know people have posted about this before but I'm gonna ask the question a little differently... I just installed PS LT headers with a Pace Setter 3 inch Off Road Y pipe and magnaflow cat back. when ever i get on it (usually lower speeds) there are several noises that I can hear and even feel it in the floor board. I know that the y could be hitting the floor but when I look under the car the y only touches the thing that looks like a drive shaft loop. And I put a piece of rubber there so it shouldn't make too much noise from that spot. where else could all this noise be coming from? i never had this problem before the exhaust!
Originally Posted by slowjoe99
i know people have posted about this before but I'm gonna ask the question a little differently... I just installed PS LT headers with a Pace Setter 3 inch Off Road Y pipe and magnaflow cat back. when ever i get on it (usually lower speeds) there are several noises that I can hear and even feel it in the floor board. I know that the y could be hitting the floor but when I look under the car the y only touches the thing that looks like a drive shaft loop. And I put a piece of rubber there so it shouldn't make too much noise from that spot. where else could all this noise be coming from? i never had this problem before the exhaust!
It's hitting on the drivers side floorboard. I solved the problem shoving a rubber exhaust hanger in between the floorboard and y-pipe.
The engine moves a bit in the cradle, which is normal. When it torques over, the y-pipe is hitting. You could try to adjust the exhaust to not hit but I don't know if that will work for you or not.
Originally Posted by slowjoe99
i know people have posted about this before but I'm gonna ask the question a little differently... I just installed PS LT headers with a Pace Setter 3 inch Off Road Y pipe and magnaflow cat back. when ever i get on it (usually lower speeds) there are several noises that I can hear and even feel it in the floor board. I know that the y could be hitting the floor but when I look under the car the y only touches the thing that looks like a drive shaft loop. And I put a piece of rubber there so it shouldn't make too much noise from that spot. where else could all this noise be coming from? i never had this problem before the exhaust!
i bought some heater hose at AZ, ran a zip tie through the hose and placed it where the ory was closes to the floorboard...and presto....been on there for almost a yr and no porbs.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Originally Posted by 00PewterSS
Install poly engine mounts. That will fix the problem.
Brian
Brian
Yeah, its hitting due to flexing motor mounts and tranny mount. Replace all with Poly ones and be done with it for good.