Need help with the installation of my MTI LId dont really know were some of the parts go here are pictures of the problem that I have. My first question is do i put the breather filter on the hole that the lid has or do i put it on the hose that i disconnected from the original factory lid? Also what do I do with the sensor connection that use to be connected to my old stock lid ? So basically where do i put the breather filter and do i plug in the hole in the lid and what do i do with the sensor connection? Its getting me confused..lol..Thanks a lot guys.

http://i225.photobucket.com/albums/d...JESSECAR-7.jpg

http://i225.photobucket.com/albums/d...JESSECAR-6.jpg

http://i225.photobucket.com/albums/d...JESSECAR-5.jpg

http://i225.photobucket.com/albums/d...JESSECAR-4.jpg

http://i225.photobucket.com/albums/d...JESSECAR-3.jpg

http://i225.photobucket.com/albums/d...JESSECAR-2.jpg

 

put the filter on the hose like you did in pic 3. take the IAT sensor off of your stock lid and place it in the hole in your new lid. this isn't hard man

 

https://ls1tech.com/forums/new-ls1-owners-newbie-tech/213148-jrp-s-faq-commonly-asked-questions.html

http://www.installuniversity.com/ins...sity/index.htm

http://www.ls1howto.com/index.php?article=10

 

^^^kinda what i was thinking, just didnt want to be the first to say it.

 

lol..thanks guys i got it

 

It is the newbie tech section guys. As a newbie, searching is something you learn after your 1st post of comments like those above!

 

Agreed. No, it's not very hard to install a lid. But the purpose of this section is for newbies to ask questions without being flamed.

 

i'm just surprised that the lid didn't come with a 1 sheet instruction on the 5 step process of installing a new lid

 

would have been usefull..lol