I have just a basic NX kit and a gen x-2 accessory with the heater. It is nonrelayed...I'm wanting to redo my kit and heater since I got the nitro daves switch panel, and wondering which relays I need to use. Can I just get them from the parts store, or do I need to get them from a sponsor?

 

You can get them at most part stores, unless you also want the pigtail harness that comes with them. Make sure you get a high enough amp draw relay for the accessory you're using.

Nick

 

30A will probably work, but check the amperage draw on the accessory to be sure and use the correct gauge wire.

 

I'm going to do both of my noids and the heater. 30 amp on both is acceptable?

 

We send out 40 amp relays with the kits. What kit do you have? I would call the mfg and see what the amp draw is on them.

Nick

 

I have the nx basic kit (non carbon fiber looking ones)

 

You should be fine going to Autozone or Napa and getting a 30A relay. If they have 40's, you could do that too.