2009 New Official "Nitrous Fast List"
#21
1/8 mile time
6.07 119.17mph--1.42--300 shot (DRY)--ericg69ss--02 Trans Am--TH400--09/10--275DR
Hard to see on the video but this was the last pass I made before I sold the motor. Track was **** that day and had to footbrake it. Gunning for that 8 second slip when the new combo is finished and running. Night vision video FTW!
Hard to see on the video but this was the last pass I made before I sold the motor. Track was **** that day and had to footbrake it. Gunning for that 8 second slip when the new combo is finished and running. Night vision video FTW!
#22
10.54@134--1.53--100 shot--Jdaniel--'99 FRC Corvette--MN6 6spd--16-Oct-2009--#22
I know that 2009 is almost over with but more times will come for 2010. Here is my time slip and a video!
http://www.youtube.com/watch?v=eK1lrYNSKe8
Here is a break down of the mods and I was spraying a 100 shot!
1999 Corvette FRC
Cartek Stage 4X heads. Includes, full porting heads intake, exhaust, and combustion
chamber, Manley sever duty stainless valves, 2.02 intake, 1.57 exhasut, seals, Manley dual springs, spring seats, seals, titanium retainers, milled .030, cleaned and assembled.
Custom grind Cartek Stage 2X Cam computer verified.
228-232 582-598 116LSA
Cromoly hardened push rods.
Cometic heavy duty head gaskets.
ASP under drive pulley with belts.
Roll master dual roller timing chain.
Z06 ported oil pump setup for the roll master.
FAST 3 piece intake manifold ported to 4X with a 90MM throttle opening.
Ported LS2 throttle body.
ECU Reprogram 97-2004 LS1 full dyno tune.
Notch piston for clearance.
Complete NX system includes, NX wet kit with 10# bottle, purge, MSD digital RPM window switch, timing retard module, custom switch panel with micro switches and LED lights, all wires, Bosch relays. Also includes, blow down tube, full throttle switch, Kenny Bell Boostapump, and NGK TR6 spark plugs.
Nitrous Outlets Fully automated aluminum bottle heater
4.10 gears.
C5 passenger and driver side 300M output shaft with side gear.
C5 line lock kit includes pre-bent line with braided flex hose, inline line lock solenoid, and switch installed.
Vararam intake
Vararam Power duct
GM Racing spark plug wires
160* thermostat
New Coolant crossover
American Racing Headers (1 7/8 primaries 3" collector)
American Racing 3" X pipe
Borla Stinger 2.5" catback
Built tranny by Lethal Performance
Hurst C6 short throw shifter
Spec III Clutch and Billet aluminum flywheel
Brand new Slave cylinder
Upgraded Tick Performance Master cylinder
Innovate LC1 Wideband
I know that 2009 is almost over with but more times will come for 2010. Here is my time slip and a video!
http://www.youtube.com/watch?v=eK1lrYNSKe8
Here is a break down of the mods and I was spraying a 100 shot!
1999 Corvette FRC
Cartek Stage 4X heads. Includes, full porting heads intake, exhaust, and combustion
chamber, Manley sever duty stainless valves, 2.02 intake, 1.57 exhasut, seals, Manley dual springs, spring seats, seals, titanium retainers, milled .030, cleaned and assembled.
Custom grind Cartek Stage 2X Cam computer verified.
228-232 582-598 116LSA
Cromoly hardened push rods.
Cometic heavy duty head gaskets.
ASP under drive pulley with belts.
Roll master dual roller timing chain.
Z06 ported oil pump setup for the roll master.
FAST 3 piece intake manifold ported to 4X with a 90MM throttle opening.
Ported LS2 throttle body.
ECU Reprogram 97-2004 LS1 full dyno tune.
Notch piston for clearance.
Complete NX system includes, NX wet kit with 10# bottle, purge, MSD digital RPM window switch, timing retard module, custom switch panel with micro switches and LED lights, all wires, Bosch relays. Also includes, blow down tube, full throttle switch, Kenny Bell Boostapump, and NGK TR6 spark plugs.
Nitrous Outlets Fully automated aluminum bottle heater
4.10 gears.
C5 passenger and driver side 300M output shaft with side gear.
C5 line lock kit includes pre-bent line with braided flex hose, inline line lock solenoid, and switch installed.
Vararam intake
Vararam Power duct
GM Racing spark plug wires
160* thermostat
New Coolant crossover
American Racing Headers (1 7/8 primaries 3" collector)
American Racing 3" X pipe
Borla Stinger 2.5" catback
Built tranny by Lethal Performance
Hurst C6 short throw shifter
Spec III Clutch and Billet aluminum flywheel
Brand new Slave cylinder
Upgraded Tick Performance Master cylinder
Innovate LC1 Wideband
Last edited by jdaniel; 10-26-2009 at 05:44 PM.
#25
#34
Man I feel cheated, lol, my list I have been doing for years. How come ya never even PMed me or E-Mailed, I looked?
You know the original list should at least be linked. Why? Well I do lists at the Corvetteforum too, just for insight, and many, many go to the posts on the run for information. At the vette forum I also include the post number for this exact reason. Something to consider. Also, wasn't there links for the prior years? this was used for comparason among other reasons and another reason tolink the original thread. It is a lot of work to keep everything lined up isn't it, most don't see this?
Man I am sorry I fell behind, however, serious issues have been at hand for the last year. I do know that Noyzee Pm a month back and was going to help and a few others asked for updates. All mods had access to help. However, one mod that is listed in all the years I have been here he never once posted in the section he was a mod in, lol. Gosh, couldn't you guys give me the benefit of the doubt?
Robert
You know the original list should at least be linked. Why? Well I do lists at the Corvetteforum too, just for insight, and many, many go to the posts on the run for information. At the vette forum I also include the post number for this exact reason. Something to consider. Also, wasn't there links for the prior years? this was used for comparason among other reasons and another reason tolink the original thread. It is a lot of work to keep everything lined up isn't it, most don't see this?
Man I am sorry I fell behind, however, serious issues have been at hand for the last year. I do know that Noyzee Pm a month back and was going to help and a few others asked for updates. All mods had access to help. However, one mod that is listed in all the years I have been here he never once posted in the section he was a mod in, lol. Gosh, couldn't you guys give me the benefit of the doubt?
Robert
Last edited by Robert56; 12-14-2009 at 07:41 PM.
#35
Thread Starter
9 Second Club
iTrader: (21)
Joined: Apr 2006
Posts: 3,240
Likes: 1
From: sacramento, CA
Sorry man, hope you arent pissed at me, I just wanted an updated list like many others and decided to ask and take it over. You can do it next year if you want to keep up on it, If not I am on here litterally every single day so it is not a big deal to me. There were no past links to other years in your 2009, I copied everything to this one.
and yes it is a lot to keep aligned, adding one is a lot of fun with a big list but no big deal.
-Cameron
and yes it is a lot to keep aligned, adding one is a lot of fun with a big list but no big deal.
-Cameron
#36
Sorry man, hope you arent pissed at me, I just wanted an updated list like many others and decided to ask and take it over. You can do it next year if you want to keep up on it, If not I am on here litterally every single day so it is not a big deal to me. There were no past links to other years in your 2009, I copied everything to this one.
and yes it is a lot to keep aligned, adding one is a lot of fun with a big list but no big deal.
-Cameron
and yes it is a lot to keep aligned, adding one is a lot of fun with a big list but no big deal.
-Cameron
That's been a problem here for some time, the mods outside of Noyzee are not even interested in the nitrous section. When I was mod here I put 98% of my posts here and was active daily, maybe they will realize that dedication means something and reinstate my position as I no longer sell nitrous kits so cry-babies can't complain, lol, about conflict of interest. By the way, it looks like the list picked up some in the last month or so, it seemed way slower this year for a long time. It must be a sign of the times. I know I didn't get any runs to post and that is unusual. I will see if I can find the prior years to add links. I know '08 had the links, IIRC and at least '07 did?
Thanks for responding, that in of itself means a lot to me.
Robert
Last edited by Robert56; 12-15-2009 at 12:26 AM. Reason: remove sig to clean up thread.
#37
Thread Starter
9 Second Club
iTrader: (21)
Joined: Apr 2006
Posts: 3,240
Likes: 1
From: sacramento, CA
Cool sounds good to me. We will figure it out. Yea I do lists on other boards as well and am a neat freak so it has to look good to me or I wont post it. **** I guess. I have been here for awhile listening and learning and now able to offer help to most so now post a lot more in the section as I know a lot more compared to before. People come and go but Ill be around for awhile while procrastinating on the internet rather then doing school work or studying for finals like I am doing right now. haha.
pm me whenever and we can decide on what to do, so we dont clutter this bad boy up. lol.
-Cameron
pm me whenever and we can decide on what to do, so we dont clutter this bad boy up. lol.
-Cameron
#38
Cool, will do, PM from here on. When I was mod doing the list I could go in a delete un-needed posts. This really helps clean up the entire thread making it easy for guys to seek info rather than BS, LOL. I know I like reading about certain combos to see what they have done. Maybe next year we can add the Post # so it's easy to find specific run info and details...
Robert
Robert
#39
Updated Time.....
10.96@129.74--1.78--200 shot--CanadianEh!--2001 Conv Camaro Z28--A4--09/18/09,--Post
Run on heavy steet rims. Just got new Weld Pro Stars for Christmas along with NANO and dedicated fuel system....hoping for low-mid 10 seconds runs in 2010!
Run on heavy steet rims. Just got new Weld Pro Stars for Christmas along with NANO and dedicated fuel system....hoping for low-mid 10 seconds runs in 2010!