Questions on pulling timing with Interface
Questions on pulling timing with Interface I read somewhere it only pulls timing when nitrous actually sprays, how does it know when that happens?
Is there a way to test if timing is being pulled without actually spraying? Last, how does this thing wire into everything?
I want to keep it simple if possible.
Sam
Is there a way to test if timing is being pulled without actually spraying? Last, how does this thing wire into everything?
I want to keep it simple if possible.
Sam
Launching!
Joined: Aug 2007
Posts: 202
Likes: 0
From: Mckinney,TX
I installed my dry kit with Interface and Microedge myself. This was my first kit I have ever installed. I had not even rode in a LS1 with nitrous before i bought my kit. Many bottles later on a stock ride and no probs!!!
still works the same way. Just like coles said, it still activates the final relay in the system and recognizes the activation of the kit. you dont have to add fuel with it, you can still leave that set to off, or you can use it to "fine tune" your wet kit by adding just a little if you too lean.
