PAT-WS6

Will these lower the compression that much, that i wont want to go with them? Building a 400+ci motor n a big shot ive had ALOT luck using these with boost, after spraying them with copper.
I dont want to run these if it will effect the cr that much, anyone run these?

PAT-WS6

thirty views and nothing???

ls2 bait

iTrader: (11)

they wont lower it at all. they are the same thickness. they have been holding my 250 rwhp hit for 2 yrs.

PAT-WS6

they are not the same thickness they are 7 Layer MLS compared to the 6.0 Gasket that is 3 Layer MLS

ls2 bait

iTrader: (11)

They are the same thickness dude. Just thinner layers. Measure them.

Red94SS

iTrader: (2)

The 3 layer gasket is .051 thick and the LS9 gaskets are .053. Very minimal change and I know if people running them with a lot of nitrous with no problems. I am using them on my new nitrous motor as well.