Nos mini progressive controller?? (wiring)
Thread Starter
On The Tree
Joined: Mar 2008
Posts: 100
Likes: 1
From: Durant ok
Nos mini progressive controller?? (wiring) Need some help, would like to have someone tell me how to wire this up on a f-body. Had this on a carb motor and worked fine but not sure my car. Also have the lnc-002 on there if that matters.It will be for a single stage. Just want wiring instructions with a wot switch.
Last edited by redriver racing; Jan 13, 2012 at 10:12 PM.
Thread Starter
On The Tree
Joined: Mar 2008
Posts: 100
Likes: 1
From: Durant ok
Would like to put the progressive on a toggle switch and keep my wot switch. The only time i use it is on street. I know u can chenge it to 100 percent all the time but right now she works like a champ.
Guess Im not following ya here, bc you can set it however you want. You don't have to use the progressive, or any of the options. You can set it however you want. Use the toggle to activate it and done. U can set everything at 100% and and zero out the window switch. Gotta keep it simple
Last edited by krissoto; Jan 14, 2012 at 08:58 PM.
TECH Fanatic
Joined: Sep 2003
Posts: 1,058
Likes: 1
FOR WOT SWITCH ONLY:
WHITE - To positive side of arming switch
BLUE - To Ground side of both Solenoids
WHITE/BLUE - To WOT Switch on Throttle Body
Note: I would set TPAS to 00; one side of the micro-switch to
ground and on trigger to the WHITE/BLUE wire.
YELLOW - To negative side of Relay for solenoids
GREEN - Directly to Ground. Set window to .00 and .99
BLACK(small) - Ground
BLACK(large) - Ground
Only used for two stage:
ORANGE - Tape off unless using a two stage
WHITE/RED - Tape off unless using a two stage
RED - Tape off unless using a two stage
Instructs at this Link:
NOS Mini 15974 Dual Nitrous Controller
WHITE - To positive side of arming switch
BLUE - To Ground side of both Solenoids
WHITE/BLUE - To WOT Switch on Throttle Body
Note: I would set TPAS to 00; one side of the micro-switch to
ground and on trigger to the WHITE/BLUE wire.
YELLOW - To negative side of Relay for solenoids
GREEN - Directly to Ground. Set window to .00 and .99
BLACK(small) - Ground
BLACK(large) - Ground
Only used for two stage:
ORANGE - Tape off unless using a two stage
WHITE/RED - Tape off unless using a two stage
RED - Tape off unless using a two stage
Instructs at this Link:
NOS Mini 15974 Dual Nitrous Controller
Trending Topics
TECH Fanatic
Joined: Sep 2003
Posts: 1,058
Likes: 1
The other option is you can hook it up to either a negative side of a coil or the PCM pin. If you use the PCM pin, the rpm tach setting is 04, otherwise I think they mention 01.
If I were you , I would hook up the window switch in case you want to use it later and set it from 0-9900
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
