HSW Microedge Interface Settings Please Help
HSW Microedge Interface Settings Please Help Trying to get the Standard Interface to fire my noids and use it as a simple window switch but it pulses them rapidly and then it shuts them down in between the window range.
Can someone with experience please give me a walkthrough on setting it up. Have asked Harris Speedworks via Trouble ticket and at first they were helpful but are not answering my questions.
At this point I have already performed a reset of the Inteface and set it to default
Isolated/Checked my grounds, fuses etc.and also my relays and they are functioning fine. Also I need to add my solenoids work perfectly with a microswitch so they are already isolated.
My car is an LS2 TBSS
Tps Signal = 4V off of purple wire at the throttle body
Tach Signal = injector wire
Thanks In Advance
Can someone with experience please give me a walkthrough on setting it up. Have asked Harris Speedworks via Trouble ticket and at first they were helpful but are not answering my questions.
At this point I have already performed a reset of the Inteface and set it to default
Isolated/Checked my grounds, fuses etc.and also my relays and they are functioning fine. Also I need to add my solenoids work perfectly with a microswitch so they are already isolated.
My car is an LS2 TBSS
Tps Signal = 4V off of purple wire at the throttle body
Tach Signal = injector wire
Thanks In Advance
