PaSteLaSo4U

iTrader: (-2)

???? rpcase?

dekan513

iTrader: (2)

well , i just bought a lnc-2000 , the hsw interface is above my head lol, so i have 1 with a 5wire harness , i pluged it up and couldnt figure it out. so if anyone needs one pm me . ill let it go cheap or will trade for nitrous stuff.
its a brand new a buddy had it layin around for a while but its never been accually used ,i just pluged it in the maf and flipped a few switches .

rpcase

iTrader: (9)

Yes you should be able to use it as a ground out or 12v out

PaSteLaSo4U

iTrader: (-2)

thank you sir.
Now i just gotta figure out if i should treat the interface as an ls6 car since i have an ls6 crate motor and the delphi t/b.... i think i should but not 100%..?

rpcase

iTrader: (9)

If its an LS6 specific sensor then treat it as if you were installing it on an LS6

PaSteLaSo4U

iTrader: (-2)

Just tried to hookup the interface, blue wire used as the trigger 12v in, and brown as 12v out but, the jet didn't spray. Wondering what i did wrong. Tried ls1 and ls6 mode on maf settings but no luck. The 3 green Led's where solid tho when i cranked her over

PaSteLaSo4U

iTrader: (-2)

what happens if the blue and/or brown wire don't get hooked up? would it still pull timing? can i run the blue wire spliced into the triggered wire going to the wot microswitch?

rpcase

iTrader: (9)

Im not sure but I dont think it will pull timing that way....It pulls timing only when it gets the signal from the blue wire.

PaSteLaSo4U

iTrader: (-2)

k, so T splicing wont work?

carlrx7

Here is the install for another controller, I think its the Micro Edge Plus.

rename as a pdf, had to upload as a tune so it would fit.

-Carl