pressure switch
Thread Starter
Launching!
Joined: Oct 2012
Posts: 219
Likes: 0
From: near Beech Bend race way
pressure switch I notice that my bottle pressure the last time i ran at the track was high the system had be set up by some one else 1250 psi before the heater shuts off , of coarse it really pulls hard when i frist hit it , but the bottle dose not recover much between shifts,
thinking it would be better at 1050 pis not sure or sould it be better at 950 psi, what do u guy think
on to the next thing adjusting my switch
can i set the switch with an empty bottle it dose have pressure in it or dose it need to have nos in it ???
just tring to save so nos by not opening the bottle up checking it, letting it cool down adjusting it, then heating it back up to see where its at at $5 a lb im greedy with that stuff
input would be great ,
thinking it would be better at 1050 pis not sure or sould it be better at 950 psi, what do u guy think
on to the next thing adjusting my switch
can i set the switch with an empty bottle it dose have pressure in it or dose it need to have nos in it ???
just tring to save so nos by not opening the bottle up checking it, letting it cool down adjusting it, then heating it back up to see where its at at $5 a lb im greedy with that stuff
input would be great ,
10 Second Club
Joined: Aug 2010
Posts: 4,465
Likes: 192
From: Harford Co. Maryland
Here's a close "Guide" you could go by IF you have a way to check the temp.
http://www.nitroussupply.com/bottletemp.php
http://www.nitroussupply.com/bottletemp.php
