Where the heck are your window switches?

Reply Subscribe

Thread Tools

Search this Thread

Jul 2, 2004 | 03:28 AM

Z28Venom

Thread Starter

TECH Addict

iTrader: (13)

Joined: Jan 2004

Posts: 2,900

Likes: 1

From: USN, Haze Grey and Underway

Where the heck are your window switches?

I've saved just about every nitrous install photo that I could find, but I haven't seen a window switch in any of the installs. Do you guys install them inside of the car or something?

Show pics of how yours are mounted if you don't mind.

Jul 2, 2004 | 07:18 AM

Josh

TECH Fanatic

iTrader: (9)

Joined: Feb 2002

Posts: 1,061

Likes: 0

From: West Lafayette, IN

I've seen them mounted on the strut towers. Can't tell you how it's done, though.

Josh

Jul 2, 2004 | 12:13 PM

CamaroCain

TECH Veteran

iTrader: (1)

Joined: Nov 2001

Posts: 4,167

Likes: 0

From: Houston,TX

Behind the glove box

We mounted ours behind our glove box, extremely clean vs under the hood and easy to switch pills since you can just flip down the glove box. We used 2-sided tape to stick it to the back of the box.

Good luck!

Attached Thumbnails

Where the heck are your window switches?-windowswitch1.jpg

Jul 2, 2004 | 12:16 PM

8 Second Club

iTrader: (34)

Joined: Nov 2001

Posts: 10,852

Likes: 1

From: Knoxville, TN

mine is stuck to the top of the radio, just pop off the radio bezel to swap pills - not like something you do a lot. I did it because my shift light is right there anyhow so 12v and the tach signal was already there

Jul 2, 2004 | 12:25 PM

Turo

TECH Junkie

iTrader: (23)

Joined: Aug 2003

Posts: 3,465

Likes: 0

From: Tallahassee, FL

under the hood, passenger side fender.

Jul 2, 2004 | 12:43 PM

SDB

10 Second Club

iTrader: (7)

Joined: Mar 2003

Posts: 2,327

Likes: 2

I run a timing tuner box, and put it on teh drive side strut tower by the battery

Jul 2, 2004 | 01:03 PM

Ed Blown Vert

11 Second Club

iTrader: (2)

Joined: Nov 2001

Posts: 3,066

Likes: 0

From: Sunny San Diego

Mounted? Damn, mine is just siiting in front of the PCM.

Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?

Pouria Savadkouei

Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine

Verdad Gallardo

7 Most Reliable High-Performance Engines GM Has Ever Built

Verdad Gallardo

Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin

Verdad Gallardo

6 Common C5 Corvette Failures and What's Involved In Repairing Them

Pouria Savadkouei

Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph

Verdad Gallardo

Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked

Pouria Savadkouei

Top 10 Most Powerful Chevy Trucks Ever Made!

Hennessey's New Supercharged Silverado ZR2 Has 700 HP

Verdad Gallardo

Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes

Verdad Gallardo

Jul 2, 2004 | 01:43 PM

xaon

TECH Fanatic

iTrader: (12)

Joined: Jan 2002

Posts: 1,737

Likes: 1

From: Tomball, TX

my harlan is ziptied to the wiring harness under the dash panel on the driver's side of the car. out of sight, out of mind.

Jul 2, 2004 | 01:45 PM

#10

Bad30th

12 Second Club

iTrader: (13)

Joined: Nov 2001

Posts: 1,898

Likes: 0

From: San Diego, CA

Mine's ziptied to the ECM wiring harness next to the ECM under the hood.

Bad30th

Jul 2, 2004 | 03:20 PM

#11

NicD

7 Second Club

iTrader: (7)

Joined: Nov 2001

Posts: 3,184

Likes: 701

From: Chandler, AZ

In the glove box.

Jul 4, 2004 | 03:40 PM

#12

flydigs

Teching In

Joined: Mar 2003

Posts: 6

Likes: 0

From: Miami, FL

I wired mine up behind the radio.

Jul 4, 2004 | 03:55 PM

#13

Z28Venom

Thread Starter

TECH Addict

iTrader: (13)

Joined: Jan 2004

Posts: 2,900

Likes: 1

From: USN, Haze Grey and Underway

I think that I'll do either the glove box or the radio area. I already have the Raptor shiftlight, so installation should be a breeze. Thanks for the photos guys..