Nitrous + Blower

Reply Subscribe

Thread Tools

Search this Thread

Jun 11, 2005 | 10:40 AM

TRANSAMWS6-98

Thread Starter

Staging Lane

iTrader: (1)

Joined: Mar 2005

Posts: 73

Likes: 0

From: Illinois

Nitrous + Blower

Is it bad if i was to spray with low compression heads , a turbo cam, and a vortec supercharger with an after cooler, plus all bolt ons?

Jun 11, 2005 | 10:51 AM

8 Second Club

iTrader: (34)

Joined: Nov 2001

Posts: 10,852

Likes: 1

From: Knoxville, TN

If its done right the only thing you will hurt is your cheeks from the smile it will put on your face. Just a 50 shot will work wonders, it dropped 1/2 a second on my old ATI car and a 15lb bottle lasted forever. I would mainly use it when it was hot out to keep the car running in the 10s on a 90 degree day. Here is a vid of it with a 50 shot on the blower on a 85 degree 90% humidity evening - it works

Click here to see Video

Jun 11, 2005 | 12:14 PM

99Z51R

9 Second Club

iTrader: (18)

Joined: Feb 2004

Posts: 101

Likes: 0

From: IA.

Quote:

Originally Posted by TRANSAMWS6-98

Is it bad if i was to spray with low compression heads , a turbo cam, and a vortec supercharger with an after cooler, plus all bolt ons?

Not at all, but as suggested stay with a small shot, unless your forged. I ran a 50 on top of my mag before going forged. I just installed a second stage on top of the 100 shot I now have on my forged bottom. Can't wait to get it dyno'd with this set up

I'll launch with the first stage around 50 then come on with the second stage of 100-150

Jun 11, 2005 | 01:05 PM

black_z

12 Second Club

iTrader: (4)

Joined: May 2003

Posts: 3,322

Likes: 0

From: Midwest

Been to CF lately? I remember watching your car break right out of the hole last year, did it end up being the clutch?

Jun 11, 2005 | 01:43 PM

99Z51R

9 Second Club

iTrader: (18)

Joined: Feb 2004

Posts: 101

Likes: 0

From: IA.

Quote:

Originally Posted by black_z

Been to CF lately? I remember watching your car break right out of the hole last year, did it end up being the clutch?

Nope, it was the output shaft. Snapped clean as a whistle. Now have hardened shafts and a strut brace on the tranny. Only went once this year, made first pass on the new motor and then it was suggested that I get a roll bar

Looking at putting a wolfe in soon, I wanna see what this new set-up will do.

Eric

Reply Subscribe