Nitrous tuning with IAT

Reply Subscribe

Thread Tools

Search this Thread

Mar 7, 2006 | 07:34 PM

Michael55123

Thread Starter

On The Tree

iTrader: (3)

Joined: Jul 2005

Posts: 171

Likes: 0

From: St. Louis, MO

Nitrous tuning with IAT

Would it be possible to get the car to add the correct amount of fuel using the PE vs. IAT tables? Seems it would work fine, if you could use resistor to get the iat values way low or high on the table. You could then add fuel here, and spray? Right? Or is it just worth the extra money for the wet shot?

Mar 7, 2006 | 08:23 PM

1MEANGTO

11 Second Club

Joined: Aug 2004

Posts: 891

Likes: 0

From: minneapolis,mn

You can use the MAF for all that. There is a way to trick the IAT but it is un worth the trouble when the MAF will do all the work for you.

Mar 7, 2006 | 09:13 PM

Robert56

TECH Senior Member

iTrader: (2)

Joined: Aug 2003

Posts: 9,557

Likes: 1

From: Tacoma, WA

Are you talking about the power adder vs IAT. this table adds a fuel multiplier on top of your wot pe multiplier, only while spraying. You just log your IAT temps while spraying, then go to above table and add multiplier to the temp areas you choose. I am working with this right now. be aware some early cars do not support this opition. It's also used for turbo guys. I will be doing a full write up on this soon, to go with timing tune, two tunes in one, only for dry users though. hehehehehehehehehehehehehehehehehehehehehe