Im looking for some pictures of a LT1 with a simple nitrous set up, just a wet shot. I need to see where the solineods should be placed and what was used, because i have a kit and im not sure how i want to set it up. It needs to be very simple. Please hook me up with some pics, Thanks alot

 

 

i like the simplicity, how did u mount the brackets, because i only have 2 of them a nitrous and a fuel solenoids, obviosly but how did u mount them that way. Also how much do those two braided lines cost?

 

I thought you hooked ot up last night and ran it?

 

yeah but when i took it off, i found out that it wasnt holding right and my solinoeds were dangling because of the fuel and nitrous tubing that i got with my kit, i need to get some braided cord.

 

I just bent the NX brackets and mounted them using the bolts that hold the fuel rails down. The braided line canme with the kit but I did upgrade to the show line on the N2O side (around $21)

 

Nice clean install. Good job.
Dave

 

Thanks everyone, thats actually an old picture, it looks even better now with Dave's shiny stand alone and new CAI!!
It would look even better with a direct port! (Damn I hate being poor)

 

where would u put ur jets if u didnt have a nitrous plate?

 

When I was running the nozzle I had it Where your I.A.T. would go, I had a relocation harness for it.

Yo what it as straight as possible facing the intake. Also make sure it doesn't interfere with the hood.

 

I.A.T? do u have any picture by chance? THanks

 

I.A.T. - Intake Air Temp sensor

 

The top picture is when I had the 1LE elbow the second where the red circle is where your I.A.T. would go I put the nozzle there becuase I didn't want to drill the Tricky flow elbow. Hope this helps.

 

it sure does 30thz, so jus for clarification, the solinoeds are mounted where on the fuel rails? it looks like u have a purge solinoed?

 

yes, front two hold down bolts then bend the noid brackets to desired shape, and yes the small moid is a purge.

 

30thz did u need 4 sets of lines, the lines to the solinoeds then from the solinoeds to the jet? i only have 1 feed line, from the bottle, where does that go? do i need another line for the other solinoeds

 

http://www.nitrousexpress.com/Instructions/stage1.pdf
This should help.

 

yeah one quick question, where did u get the fuel supply from, i kno the fuel line. but where at and how did u do it.. Thanks 30thz youve been alot of help so far

 

Remove the schrader valve from the threaded fuel port, on the rear of the manifold. It's kind of like a bicycle tire valve. And then thread your line in to that.

 

so the line should jus screw into that schrader valve? Thanks