I've been doing my nitrous research like a good LS1'r and in spite of the fact that a lot of the posts I've read said the nitrous plate setup looked "more trick," (a lot of this about Dave's setup), I've still seen hardly of pics of this sort of install.

So, please, post up your "trick" nitrous plate setups.

 

Sorry old pics. The main feed line is now ran/hooked up and doing the wiring now. Hope these help you.

 

 

Here is a thread with a few more pics of this set-up.
https://ls1tech.com/forums/showthrea...hlight=install

Vinny

 

Vinny that is most definitely smooth. Would make that tq management go fn nuts.

 

mine in my myspace. dont have time to post a bunch of pics, going to work in a few.http://www.myspace.com/20675162

 

That looks almost factory on the ls2. Nice job. If the blue nitrous nut were red I'd bet you could almost get warranty work done with on. I need to get around to ordering one of dem thur plates...