i just installed my nos dry kit i am running the 75 hp jets right now to play it safe until i get on a dyno to check the a/f ratio with the 100 hp jets .i have a few questions .1) i have a window switch set to start at 3000 rpm and stop at 6000 rpm . is 3000 too low to start spraying? 2) i have ngk tr6 plugs gapped at 35 is this a good gap ?thanks

 

anyone?

 

I have mine set at 3200 rpm right now. I wanted to be on the safe side when i sprayed the first time. I just got done with the install and sprayed yesterday. Most people have theirs set at 3000 rpm. So you should be set to go. I think most n20 companies say spray above 2500 rpm.

 

thanks . anyone else with a nos dry kit have any advice? i only have the 75 hp jets in and it still makes a big difference. in general the spray is fun.the first night i put it in i roasted a z06 from 0 to about 120 and i had really poor bottle pressure.i was a little suprised how far i walked on him myself .now i have the bottle heater working and it hits much harder.

 

3K is fine.

 

3K rpms is perfect. Your TR6's will be fine too.

 

thanks