BlackhawkSS

iTrader: (3)

Alright well I havent been able to drive my car much over last 4 years and I have a 5177 kit I had installed on it but I want to spruce it up a little.

I have no FPSS
Want to upgrade the 2 solenoids to 1 larger (which to choose?)
Have the 2 smaller hoses running to the airbox still
Have purge, opener, heater

Basically just want to replace the 2 noids for one and rewire everything maybe even add a FPSS if you guys think its necessary.

Ive got 60# injectors, intake walbro and inline.

Will make a N20 only LS1 Edit file for n2o runs.

Im even open to ideas on alternate methods of wiring this up.

EDIT** Meant to add reason for replacing wires/noids is over all this time there is corrosion and a couple wires came off so figgured id do it over.

Thanks

TX RED

iTrader: (19)

i am in the same boat as you getting new brkts and and gm connetors to make a nice clean install

Matt@HSW

iTrader: (14)

You can go with one of the larger .125 orifice solenoids:

http://www.harrisspeedworks.com/shop...cat=280&page=1

along with some custom hoses and you'll have a sharp looking install:

http://www.harrisspeedworks.com/shop/home.php?cat=261

You mentioned making a N2O only tune, another option, you could run our Interface controller for fueling/timing retard, that way your not pulling timing & running rich NA:

http://www.harrisspeedworks.com/shop...age=1&featured

Let me know if you have any questions.

Thanks,
Matt