Nitrous Oxide Installation | Tuning | Products
Sponsored by:
Sponsored by:

main nitrous line question

Old Mar 24, 2008 | 03:50 PM
  #1  
BLACK 97 SS's Avatar
Thread Starter
On The Tree
 
Joined: Jan 2008
Posts: 107
Likes: 0
From: bay area
Default main nitrous line question

is there a way i can run my main line without drilling a hole through the firewall? if so can i pls see pics
Reply
Old Mar 24, 2008 | 03:58 PM
  #2  
porksoda's Avatar
TECH Addict
iTrader: (39)
 
Joined: May 2005
Posts: 2,458
Likes: 2
From: Clovis, NM
Default

There is a grommet behind the PCM. You will see where a bunch of wires runs through there if you pull out the PCM.
Reply
Old Mar 24, 2008 | 03:58 PM
  #3  
silver 2000 ss's Avatar
Teching In
iTrader: (4)
 
Joined: Dec 2005
Posts: 39
Likes: 0
From: long island,new york
Default main line

Yes you can, right side of your car take the kick panal off and you will see a spot. I got a 2000 ss and that is were I ran my line.
Reply
Old Mar 24, 2008 | 04:20 PM
  #4  
quickblade's Avatar
12 Second Club
 
Joined: Aug 2007
Posts: 508
Likes: 0
From: Rowlett
Default

run it under the car. That would be the best suggestion.. Take it down under one of the seats.. There are rubber plugs filling 4 holes in the rear seats... 1 hole under each seat, and 1 hole on the floor board in the back... under the seats is the best way.

make the grommet fit around the line, and bam... Run from driver side rear seat, then you can run it against the fuel lines, and you are in like flynn....

the feed line will come up along the engine firewall where the fuel line goes up...

easy piesy pie...
Reply
Old Mar 25, 2008 | 01:21 AM
  #5  
BLACK 97 SS's Avatar
Thread Starter
On The Tree
 
Joined: Jan 2008
Posts: 107
Likes: 0
From: bay area
Default

thanks alot guys really appreciate it
Reply


Thread Tools
Search this Thread

All times are GMT -5. The time now is 07:37 PM.