LS100CAMSS

myfast70, did you fab the noid bracket or can it be purchased somewhere?

myfast70

iTrader: (38)

No, wish I could take credit for it but I purchased it here at Nitrous Outlet. I had to modify it a bit to work with the Lightning solenoids but it worked out really good.

ss.slp.ls1

iTrader: (36)

Easily one of the best installs I've ever seen. I give you props.

Beer99C5

iTrader: (21)

Thanks, I am still tweaking, pretty much all the forum nitrous vendors helped me out...Dynotune, Nitrous Outlet, Harris Speed Works all have their parts in it. 860 Performance did the hardlines for me and the initial wiring.

Went to NED to run the quarter, still having issues, think I have valve float so I elected not to spray at the track to finally get a time.

Doing more work to it, should have a spray time after a trip to ECS for a RPM level V tranny, ZO6 rear w/ 3.42 gears (I have 3.15 now), and a small Yank convertor.

I will be fine tuning the bottle area I am going to redo the deck cover to extend to the pass side more and reroute the bottle wires.

Oh yeah, getting a removable Hardtop to get around the rollbar and plan to run in the 11.5 class.

bluebeast

iTrader: (1)

so does the nitrogen assist just keep the bottle pressure up through a nitrous run???? never heard much about this yet

LS2Camaro

iTrader: (5)

I am going to have a surprise for you guys that want to see a nice Viper SRT10 Nitrous setup with shall I say it, a plate system. Right now the trunk is getting fabricated for the dual bottle setup. The plate system is next. I will do a separate post when its all done but sorry guys right now I cant even do teaser pics.

ss.slp.ls1

iTrader: (36)

Yes, it keeps the bottle pressure constant no matter what your n2o level is at. The nitrogen goes to the top of the tank (it's lighter) and pushes the n2o to the bottom where the pick up tube is and keeps the pressure up.

Ruckus46Gt

iTrader: (9)

before i drilled the holes but looks the same

myfast70

iTrader: (38)

Beer,
Sweet install! How long ago did you get your NX opener? I just bought one within the last 6 months and mine uses a band clamp to secure it to the valve. Do you have any more pics of your opener? Looks like its a lot easier to take off than mine.

-Freak-

iTrader: (6)

Some damn nice setups.

bluebeast

iTrader: (1)

i would like to see some more setups as well

Nitro Dave's Nitrous Outlet

iTrader: (25)

Check out our customer pages. There are tons of installs.
http://www.nitrousoutlet.com/customerCars/index.asp

porksoda

iTrader: (39)

L3THAL_Z28

iTrader: (5)

wow...really flippin nice installs!

99_Z_155

iTrader: (7)

Here is my attempt at a "clean" install.

porksoda

iTrader: (39)

^^^Did you wrap your braided lines in rubber or something like heat shrink?

99_Z_155

iTrader: (7)

thats how harris made them for me. i just asked for them in black. they are a little more glossy in reality that in the pics.

porksoda

iTrader: (39)

Oh they don't look bad at all! Thats why i asked because I liked them.

Black FormulaLs1

iTrader: (10)

friggin sweet i love the ideas!!!!!!!!!!!!!

99_Z_155

iTrader: (7)

they werent that bad of a price either. but they could have gone up. i got em last summer.