FS:350 SBC part out or complete
04-16-2009, 09:04 PM
#1
TECH Resident
Thread Starter
iTrader: (30)
Join Date: Nov 2007
Location: Van Nuys
Posts: 823
Likes: 0
Received 0 Likes
on
0 Posts
FS:350 SBC part out or complete Selling my sbc 350 motor out of my 84 corvette. Decided to do a different route again!
bottom end is stock but cleaned up and checked
parts it has:
New PAW 224/224 .436 109 Lobe set w/lifters SOLD
Rebuilt Vortec heads with new .500 Springs SOLD
Ebay vortec manifold SOLD
Rebuilt Holley 670cfm truck avenger carb w/both throttle bracket and 700r4 kickdown bracket (paid $400 sell for $250)
Holley Fuel pressure regulator (paid $45 sell for $35)
Ebay (MSD knock off) distributor w/Accel wires and head plugs SOLD
PAW double roller timing chain
Smog and a/c deleted
Fel-pro gaskets
EVERYTHING IS O.B.O. SO FEEL FREE TO MAKE OFFERS AND CONTACT ME ON SHIPPING
still in car at the moment and will fire up if needed.
motor was first started on 2/1/09.
Dyno'd 257hp 313tq to the wheels.
BAD:
motor started drinkin water (4/16/09) parked it and do not know where it is leakin from.
will need rockers (takin them for new motor)
pics of parts and some videos of the first time fired and a dyno run.
video of first time starting with open headers
http://www.youtube.com/watch?v=WnU8YeyGF0k
video of dyno pull after tuning
http://www.youtube.com/watch?v=iMHkABiT0sA
bottom end is stock but cleaned up and checked
parts it has:
New PAW 224/224 .436 109 Lobe set w/lifters SOLD
Rebuilt Vortec heads with new .500 Springs SOLD
Ebay vortec manifold SOLD
Rebuilt Holley 670cfm truck avenger carb w/both throttle bracket and 700r4 kickdown bracket (paid $400 sell for $250)
Holley Fuel pressure regulator (paid $45 sell for $35)
Ebay (MSD knock off) distributor w/Accel wires and head plugs SOLD
PAW double roller timing chain
Smog and a/c deleted
Fel-pro gaskets
EVERYTHING IS O.B.O. SO FEEL FREE TO MAKE OFFERS AND CONTACT ME ON SHIPPING
still in car at the moment and will fire up if needed.
motor was first started on 2/1/09.
Dyno'd 257hp 313tq to the wheels.
BAD:
motor started drinkin water (4/16/09) parked it and do not know where it is leakin from.
will need rockers (takin them for new motor)
pics of parts and some videos of the first time fired and a dyno run.
video of first time starting with open headers
http://www.youtube.com/watch?v=WnU8YeyGF0k
video of dyno pull after tuning
http://www.youtube.com/watch?v=iMHkABiT0sA
Last edited by RPD_Vette84; 04-20-2009 at 05:04 PM.
